Lately more and more of my sets are publishing down in the corner and are about a third of the size of normally publishing set..

[heartsongs]

I am curious if anyone else has been experiencing this? sometimes I go back later and re-publish them and they are fine. On each set I have gone back to see if I have left something sticking out in the margins but this is not the reason they are publishing smaller... any help would be greatly appreciated! Thanks so much!

[jewelsinthecrown]

@heartsongs Yes Pam, happen to me too I had to ditch it and redo it and nothing was outside the margins either kinda weird I think it’s a glitch in the system somehow.

[heartsongs]

Thanks so much for sharing with me! UGH! Ok, thanks for the tip too! Have a blessed 2023 Michele!

[Ollie]

@heartsongs Hi Dear, I had it happen to me a few times before Christmas. Firstly I opened the set and checked there was no items on the outskirts of the set by running the cursor around the edge, then I centred the set and published, sometimes it would take me a couple of times of doing this but it seemed to work. Hope this helps. xx

[heartsongs]

Thanks so much @Ollie I appreciate the tip! I will try it! Happy New 2023!