I have been having a problem with the cutting tool in create...
-
It is not cutting the lines I am drawing. It comes out off the line I am drawing a few mm. Why is this happening? Is there fix @admin or anyone who knows about this? Thank you for any help.
-
@heartsongs When that happens to me I have to move all the lines inward. You have to make sure you cut tight on every side or it will go wonky on the opposite side of the cut. I can't explain it. Easier if I could show you.
-
That explanation isn't very helpful. I will try to figure out how to describe it better.
-
@laughingdog thank you for trying. It is difficult to describe writing it. Today I was trying to cut an image and 3 sides had straight lines and one side had curves but none of the straight lines turned out straight, even though I cut them straight and the curvey part was a bit better, where your suggestion may work. For me this problem has gotten progressively worse, until today where I had to give up on the PC I wanted to make. Any other ideas are welcome! Thanks for responding!
-
@heartsongs Sometime's i cut them in pieces and add them bit by bit. Might work for you?
-
@laughingdog thank you for thinking of that! I wish @admin would also respond with there thoughts too! I wonder why this is happening now and hasn't been like this before! have a good Wed!
-
@heartsongs For me this has been happening for ages off and on. Sometimes I just close everything down, clear my cookies and it seems to help a bit. However it would be great if @admin could look at it, as it is frustrating as hell!
-
